Snmp V; Snmp V. 3 Set - Canon Laser Shot LBP5970 User Manual

■ SNMP V. 1

ON*, OFF
Specifies whether the printer should use the SNMP v. 1 protocol.
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.
NOTE
For more details on SNMP v. 1, see "Chapter 2 Common Network Settings" in
•
Network Guide.
This item is displayed only when NETWORK in the I/F CONNECTION options is
•
set to ON.

■ SNMP V. 3 SET.

SNMP V. 3.............................OFF*, ON
USER SETTING 1 to 5*
AUTH .PASSWORD
ENCRYPT.PASSWRD
1
* USER SETTING 1 to 5 is displayed only when SNMP V. 3 is set to ON.
Specify the settings related to SNMP v. 3 protocol.
If you want to specify or change user information (authentication password and
encryption password) to be used in the SNMP v. 3 protocol, perform the following
procedure.
1.
Select USER SETTING N (N = 1 to 5) using [
2.
Confirm the user name*, then press [OK].
* "initial" (the default value) or the user name specified in the Remote UI is displayed.
3.
Select AUTH .PASSWORD or ENCRYPT.PASSWRD using [
[OK].
4.
Enter the password, then press [OK].
Input Method:
- Enter the password of 6 to 16 characters by pressing [
- Move the cursor to each field in which you want to enter a value by pressing [
[ ] (The cursor blinks, allowing you to enter a value.).
- If you press [Feeder Selection], a space for entering a character is created at the
cursor position.
- If you press [Cancel Job], the character at the cursor position is deleted.
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.
1
] and [ ], then press [OK].
] and [ ], then press
] and [ ].
SETUP Menu Settings
5
] and
5-63