Canon Laser Shot LBP5970 User Manual page 449

Remedy 4 If you are using the PS/UFR II printer driver and select the [Print with Upper Left
Cause 6
Remedy
The printing position is skewed.
Cause 1
Remedy
7
Cause 2
Remedy
Cause 3
Remedy
The next page is printed from halfway across the previous page.
Cause 1
Remedy
7-54 When You Cannot Obtain Appropriate Printout Results
of Sheet as Starting Point] check box in the printer driver, you can extend the
printable area to near the edges of the paper. However, data may be printed
with the edges missing.
In order to specify the setting for [Print with Upper Left of Sheet as Starting
Point], display the following dialog box.
- For UFR II Printer Driver: Display the [Finishing Details] dialog box by clicking
[Finishing Details] in the [Finishing] sheet.
- For PS Printer Driver: See Help of the PS printer driver.
The printing position has been adjusted using ADJ.START POS. in the
USER MAIN. options in the SETUP menu.
Adjust the printing position to the appropriate value using ADJ.START POS. in
the USER MAIN. options in the SETUP menu. (See "Adjusting the Printing
Position," on p. 6-62)
GUTTER, OFFSET Y, or OFFSET X in the LAYOUT MENU options in the
SETUP menu is specified.
Set GUTTER, OFFSET Y, or OFFSET X in the LAYOUT MENU options in the
SETUP menu to "0", and then print again.
"Top Margin" and "Paper Position" in the application are not specified
properly.
Specify the settings for "Top Margin" and "Paper Position" in the application
properly, and then print again. (See the instruction manual supplied with your
application)
The printing position has been adjusted using ADJ.START POS. in the
USER MAIN. options in the SETUP menu.
Adjust the printing position to the appropriate value using ADJ.START POS. in
the USER MAIN. options in the SETUP menu. (See "Adjusting the Printing
Position," on p. 6-62)
"Line Spacing" or "Lines/Page" in the application is not specified
properly.
Specify the settings for "Line Spacing" and "Lines/Page" in the application so
that data fits in one page, and print again. (See the instruction manual supplied
with your application)