Print Mode Options; Extension Card; Ext.rx Buffer; Mode Selection - Canon Laser Shot LBP5970 User Manual

EXTENSION CARD

CONNECT.RECOG.
5

EXT.RX BUFFER

PRINT MODE Options

MODE SELECTION

5-66 SETUP Menu Settings
-
This is the setting for the interface board installed in the expansion slot of the
printer. This item is displayed only when the interface board is installed. For more
details, see the instruction manual supplied with the interface board.
ON*, OFF
When you print using a network, you may not obtain proper printout results
(Unreadable characters are printed, etc.). In this case, specify OFF for this item.
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.
OFF*, ON
If this item is set to ON, the memory capacity of the printer's receive buffer that
receives the data is increased. You can speed up the time the computer exits
when you send a large amount of data or complicated data from the computer.
IMPORTANT
After changing the settings for this item, cycle the power of the printer to make the
settings effective.
NOTE
This item is displayed only when an optional RAM module is installed.
AUTO SELECTION*, PCL, PS*
1
* PS is displayed only when the optional PS ROM or PS/Barcode ROM is installed.
2
* PDF1.5 is displayed when all the following optional accessories are installed.
- Hard Disk
- PS ROM or PS/Barcode ROM
- RAM (ER-256A, ER-512A)
1 2
, IMAGING, PDF1.5*