Canon Laser Shot LBP5970 User Manual page 425

<38 LOW IMGE QLTY>
Cause
Remedy 1 The printer continues printing by pressing [Online]. However, the printer prints
Remedy 2 Perform a soft reset in the RESET menu, set RESOLUTION (See p. 5-43) in the
Remedy 3 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 5-44)
Remedy 4 If you want to print in the Super Fine mode, perform a soft reset using the
<39 SPL MEM.FULL>
7
Cause
Remedy 1 The printer continues printing by pressing [Online]. However, the page with
Remedy 2 Perform a soft reset in the RESET menu, specify the paper size smaller, and
Remedy 3 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 5-44)
Remedy 4 If 2-SIDED PRINT. in the FEEDER MENU options in the SETUP menu is set to
Remedy 5 Change the setting for HALFTONES (See p. 5-47) in the QUALITY MENU
Remedy 6 Install an optional expansion RAM module, then print again. (See Getting
7-30 Message List
The printer cannot process the data in the Super Fine mode because it is
too complicated.
with the resolution level of the data being lowered.
QUALITY MENU options in the SETUP menu to FINE, and then print again.
in the QUALITY MENU options in the SETUP menu to HIGH 1, and then print
again.
RESET menu, and then increase the free space of RAM using the following
procedure.
- Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory that the printer has received will be deleted).
- Install an optional expansion RAM module. (See Getting Started Guide)
Because spool memory has run out, the printer cannot print.
which an error has occurred is not printed.
then print again.
in the QUALITY MENU options in the SETUP menu to HIGH 1, and then print
again.
ON, specify OFF, and then print again.
options in the SETUP menu, and then print again.
Started Guide)
<Auto Error Skip>
<Auto Error Skip>