Canon Laser Shot LBP5970 User Manual page 423

<30 MEMORY FULL>
Cause 1
Remedy
Cause 2
Remedy 1 The printer continues printing by pressing [Online]. However, the data may not
IMPORTANT
The memory construction of NVRAM is rewrote to a securable value when <30
MEMORY FULL> appears. (* The settings for RIP Once and the hard disk is restored to
the default value.) (See "SETUP Menu Settings," on p. 5-18)
Remedy 2 After turning the printer OFF, restore the memory to the original condition
Remedy 3 Set EXT.RX BUFFER (See p. 5-66) in the INTERFACE MENU options in the
7
<32 2-SIDED ERROR>
Cause 1
Remedy
Cause 2
Remedy 1 The printer continues printing by pressing [Online]. However, the data on each
Remedy 2 Perform a soft reset in the RESET menu, change the paper size of the data to
<33 WORK MEM.FULL>
Cause
Remedy 1 The printer continues printing by pressing [Online]. However, the data with
7-28 Message List
The work memory has run out while the system is processing the data.
The printer continues printing by pressing [Online]. However, the data with
which an error has occurred may not be printed properly.
(If this error has occurred while the printer is ON) The amount of memory
specified in NVRAM could not be secured because the memory
construction had been changed (The expansion RAM is removed).
be printed properly due to the change of the memory construction.
(install the removed RAM), and then print again. (See Getting Started Guide)
SETUP menu to OFF, and then print again.
Paper on which automatic 2-sided printing cannot performed is selected.
Select a standard paper size for the paper source and paper size setting in the
computer, and then print again.
The printer received data for 2-sided printing on which the printer cannot
perform automatic 2-sided printing.
side is printed on two pages.
the one on which the printer can perform 2-sided printing, and then print again.
The work memory for each print mode cannot be secured.
which an error has occurred is not printed properly.
<Auto Error Skip>
<Auto Error Skip>
<Auto Error Skip>