Mode Timeout - Canon Laser Shot LBP5970 User Manual

MODE TIMEOUT

5
5-56 SETUP Menu Settings
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.
OFF, 5 to 300 seconds; 15 seconds*
Specifies the function to finish a job automatically.
If you specify the time the printer times out in this item, the printer can finish a job
automatically when the specified time has elapsed since no data is entered.
If this item is specified, the printer can output paper automatically when data is
remaining in the printer because of an application not sending the command to
output paper.
When OFF is specified, the printer does not use the function to finish a job
automatically.
IMPORTANT
If the function to finish a job automatically is specified, the job may be finished in
•
the middle of the process when the computer takes a long time to process the data.
In this case, adjust the time the printer times out.
When you are using an optional hard disk, specify the setting other than OFF for
•
this item. It is recommended that you should leave this item at the default setting,
15 seconds, if possible.
NOTE
The Job indicator on the control panel is on or blinking during a job.
•
When the printer is offline, the printer does not use the function to finish a job
•
automatically.