Installing 3.5-Inch Hdd Modules - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

7.4.2

Installing 3.5-inch HDD modules

Customer Replaceable
Unit (CRU)
Tools: tool-less
Preliminary steps
▶ Locate the correct drive bay, see
Removing a 3.5-inch HDD dummy module
Figure 62: Removing the 3.5-inch dummy module
▶ Press both tabs together (1) and pull the dummy module out of its bay (2).
CAUTION
▶
Keep the dummy module for future use.
▶
Always replace dummy modules into unused HDD/SSD bays to
comply with applicable EMC regulations and satisfy cooling
requirements.
RX1330 M4
Hard disk drive (HDD) / solid state drive (SSD)
"Overview of configurations" on page
Upgrade and Maintenance Manual
Hardware: 5 minutes
140.
141