Replacing The Hot-Plug Power Supply Unit - Fujitsu PRIMERGY RX330 S1 Operating Manual

Hot-plug power supply units
8.1.3

Replacing the hot-plug power supply unit

V
CAUTION!
Before replacing a non-defective power supply unit in a non-redundant
configuration (only one power supply unit present), the server must have
been switched off.
Ê Remove the cable of the defective power supply unit.
Ê Remove the defective power supply unit (see section
the hot-plug power supply unit" on page
Ê Install the new power supply unit in the empty mounting location (see section
"Installing/removing the hot-plug power supply unit" on page
I
Make sure that the power supply unit engages correctly in the
mounting location and is locked in position.
This is the only way to avoid the power supply unit being shaken out
of its mountings and damaged during transportation.
Ê Connect the newly installed power supply unit.
72
71).
Operating manual
Hot-plug components
"Installing/removing
71).
RX330 S1