12
To specify the processing of received documents per line
1
In the Administrator mode, click the [Fax/Scan] tab.
–
For the procedure to log on to Administrator mode, refer to
"Logging on to administrator mode" on page 12-10.
2
Click [RX Document], then [Port].
3
Click a port name (G3).
–
If the optional fax multi line is being used, two general subscriber
lines can be used. Specify settings for each port: "G3-1" (port 1)
and "G3-2" (port 2).
–
To specify settings for documents sent through the network (such
as Internet faxes), click [Network].
–
If software switch settings were specified to block faxes received
from senders other than those specified, only the setting for
"Network" can be specified. For details on the software switch
settings, refer to "Configuring Functions (Soft Switches)" on
page 11-67.
12-46
Specifying settings using PageScope Web Connection
bizhub 362/282/222