Checking The Recipient Before Sending - Konica Minolta bizhub 362 User Manual

3
3.6

Checking the recipient before sending

The machine can be set to send the fax transmission after checking the CSI
(called subscriber ID) signal received from the recipient's machine in order to
prevent misdirected fax transmissions.
- The recipient's machine telephone number must be registered in order
for the CSI signal to be checked.
- After specifying the recipient's telephone number, touch [S] to add the
special character "S" and send the document after the receiving machine
is checked.
- The telephone number and special character can be programmed in one-
touch dial buttons, and a checked receiver transmission can be per-
formed by using a one-touch dial button.
- Using the software switch settings, the machine can be set to perform
checked receiver transmissions with each transmission even if the
special character "S" is not added.
As a factory default, the machine is set to not perform the checked
receiver transmission if no special character is specified (bit 4 of mode
200 is set to "0").
If the machine is set to perform the checked receiver transmission even
if no special character is specified (bit 4 of mode 200 is set to "1"),
touching [S] twice after entering the telephone number to add the special
character "SS" cancels the checked receiver transmission operation.
For details on the software switch setting (bit 4 of mode 200) and the
procedure for specifying checked receiver transmissions, refer to the
following.
Software switch setting (bit
4 of mode 200)
0
1
3-32
When a checked receiver
transmission is performed
The recipient's telephone
number and the special char-
acter "S" are dialed.
The recipient's telephone
number is dialed. (The special
character is not added.)
Transmission
When a checked receiver
transmission is not per-
formed
The recipient's telephone
number is dialed. (The special
character is not added.)
The recipient's telephone
number and the special char-
acter "SS" are dialed.
bizhub 362/282/222