Transmitting By A One-Touch Key - Konica Minolta bizhub 362 User Manual

3

Transmitting by a One-touch Key

Perform the following procedure after storing the destination number
beforehand in the one-touch keys.
1
Press [Fax/Scan] on the control panel to open the fax screen.
– The recipient must have been registered with a one-touch dial
button in advance. For details, refer to "Programming a one-touch
dial button" on page 10-5.
– If desired, press [Quality & Reduction] or [FAX Menu], and then
specify the desired settings. For details on the settings available on
the Quality & Reduction screen, refer to "Setting transmission
conditions" on page 3-10. For details on the settings available on
the FAX Menu screen, refer to page 7-3.
2
Press [One-Touch].
3
Press the desired one-touch dial button.
– Press the index tabs and [
touch dial button.
– If you touch a key mistakenly, pressing the same key again will
release it.
The selected button is highlighted. To select multiple recipients,
continue selecting the desired one-touch dial buttons.
4
Place the original on the machine.
5
Press [Start].
Scanning of the document begins, and then the fax is sent.
If multiple recipients were selected, the Dest. tab of the Check Job
Details screen appears so that the selected destinations can be
checked. For details, refer to "Transmitting to Multiple Destinations" on
page 3-28.
3-22
] and [ ] to find the desired one-
bizhub 362/282/222
Transmission