Panasonic DP-C321 Service Handbook page 91

003-959 Size Mismatch Tray 1 Size Mismatch
BSD on : CH7.10A
[Detection Conditions]
The paper size in Tray 1 and the paper size specified
for printing are different.
[Actions]
Load the correct paper in the tray.
If the problem persists, check the SENSOR using
Generic Permeable Sensor Failure FIP.
003-960 Size Mismatch Tray 2 Size Mismatch
BSD on : CH7.10A
[Detection Conditions]
The paper size in Tray 2 and the paper size specified
for printing are different.
[Actions]
Load the correct paper in the tray.
If the problem persists, check the SENSOR using
Generic Permeable Sensor Failure FIP.
003-961 Size Mismatch Tray 3 Size Mismatch
BSD on : CH7.10A
[Detection Conditions]
The paper size in Tray 3 and the paper size specified
for printing are different.
[Actions]
Load the correct paper in the tray.
If the problem persists, check the SENSOR using
Generic Permeable Sensor Failure FIP.
3-17
003-962 Size Mismatch Tray 4 Size Mismatch
BSD on : CH7.10A
[Detection Conditions]
The paper size in Tray 4 and the paper size specified
for printing are different.
[Actions]
Load the correct paper in the tray.
If the problem persists, check the SENSOR using
Generic Permeable Sensor Failure FIP.
003-965 ATS/APS No Paper, APS/ATS NG (No
Paper)
BSD on : CH7.10A
[Detection Conditions] The paper specified for printing is
not loaded in the tray.
[Actions]
Load the correct paper in the tray.
If the problem persists, check the SENSOR using
Generic Permeable Sensor Failure FIP.
003-966 ATS/APS No Destination Error, ATS/APS
NG (Except No Paper)
BSD on : CH7.10A
[Detection Conditions] The paper specified for printing
cannot be detected.
[Actions]
Change the settings.
If the problem persists, check the SENSOR using
Generic Permeable Sensor Failure FIP.
003-971 Magnification Mismatch
BSD on : CH6.12B
[Detection Conditions] Magnification Mismatch
[Actions] Change the parameter and perform the operation
again.
003-972 Over Maximum No. of Pages that can be stored
BSD on : CH6.12B
[Detection Conditions] Over the maximum No. of pages
that can be stored
[Actions] Set the number of pages to the maximum
number of pages that can be stored or less.
003-973 Vertical/horizontal number mismatch (When
other than Poster is selected and the switch
of rotations is not displayed.)
BSD on : CH6.12B
[Detection Conditions]
Vertical/horizontal number mismatch (When other
than Poster is selected and the switching of rotations is
not displayed.
[Actions] No actions required.
003-974 Next Document Specified
BSD on : CH6.12B
[Detection Conditions] Next Document Specified
[Actions] No actions required.
003-975 Document replacement request (When 2-
sided is selected and the Platen is used for
scanning)
BSD on : CH6.12B
[Detection Conditions]
Document replacement request (When 2-sided is
selected and the Platen is used for scanning)
[Actions] No actions required.
003-980 Staple Position Error
BSD on : CH6.12B
[Detection Conditions] Staple is not available at the
specified position.
Chapter 3 Troubleshooting