Panasonic DP-C321 Service Handbook page 274

3-200
3. 5. 5 DC612 Test Pattern Print (PG) List
PG
Pattern Name Overview
No.
1 LSU (ROS) Seal Glass Cleaning
Check Guide: 20 % Half
Tone Full Band Width
KCMRY Fast Scan
direction Stripe
Pattern
2 Halftone (IOT) Seal Glass Cleaning
Guide: 20% Half
Tone Full Band Width
Full Half Tone. Select
the density from
Cin=0~100.
3 Grid 1dot (For separating
troubles) 512 dot
Pitch Grid Pattern
with 1 dot width
4 Fast Scan 8 (For separating
Gradation troubles) Fast Scan
direction 8 Gradation
Pattern
5 A1 Patch Forms a bi-axial near
the IN and OUT edges
in full color.
(Chevron Pattern) At
normal Regi Control
cycle: Approx. half
cycle of IBT Belt (2
sheets of 8.5 x 11"
continuous) At Diag
Regi Control cycle:
Approx. 1 cycle of
IBT Belt (1: 4 sheets
of 8.5 x 11"
continuous)
Purpose PG Built-in Location
The engine where IOT
defect has occurred
can be determined as
an output sheet
contains Seal Glass
smearing. -> To
determine defect
engine
Defect can be IOT
detected/evaluated
(steaks, uneven
density, banding)
- Around Alignment IOT
and Color Regi
- Secondary Transfer
part magnification
failure
For development. IOT
For ASIC debug.
For Color Regi Controller
adjustment in Diag
DC685-1 (Skew Fine
Setup) and DC685-2
(In/Out Setup) during
JOB, at beginning of
JOB and end of JOB.
Also, for Color Regi
reading in DC681 and
DC684.
PG
No. Pattern Name Overview
6 A2 Patch Forms a 1 axial near
CNT for approx. 1
cycle (1: 4 sheets of
8.5 x 11" continuous)
of IBT Belt in full
color. (Chevron
Pattern)
7 B1 Patch Forms a bi-axial near
the IN and OUT edges
for approx. 1 cycle (1:
4 sheets of 8.5 x 11"
continuous) in full
color. ("<" pattern)
8 B2 Patch Forms a 1 axial near
CNT for approx. 1
cycle (1: 4 sheets of
8.5 x 11" continuous)
of IBT Belt in full
color. ("<" pattern)
9 C Patch Forms a three-axle IN/
CNT/OUT in approx.
1 cycle (1: 4 sheets of
8.5 x 11" continuous)
of IBT Belt in single
color C. (Chevron
Pattern)
Chapter 3 Troubleshooting
Purpose PG Built-in Location
For Color Regi Controller
adjustment in Diag
DC685-3 (Center
Setup)
For Color Regi rough Controller
adjustment in Diag
DC685-1 (Skew Fine
Setup) and 685-4
(Skew Rough Setup).
For Color Regi Controller
adjustment in Diag
DC685-3 (Center
Setup)
For Diag DC683 (to Controller
check Sensor, Cyan
and position shift).