Panasonic DP-C321 Service Handbook page 252

3-178
Turn On the document exchange command signal to the DADF
On: Low
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: -
[Reference BSD]: CH5.2
29. 007-003
SMH FEED Clutch
[PSW Display]: SMH FEED Clutch
[Operation Description]:
On
On: Low
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: -
[Reference BSD]: CH8.1
30. 007-004
HOTLINE_TRAY
[PSW Display]: HOTLINE_TRAY
[Operation Description]:
Not used.
On: -
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: -
[Reference BSD]: -
31. 008-001
#1Feed Motor (Fwd)
[PSW Display]: #1Feed Motor (Fwd)
[Operation Description]:
Feed (Rotate #1Feed Motor in paper feed direction at 200mm/sec)
On: Every 4 phase High/Low toggling
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-002
[Reference BSD]: CH7.5
32. 008-002
#1Feed Motor (Rev)
[PSW Display]: #1Feed Motor (Rev)
[Operation Description]: Lift Up
It turns Off automatically 6sec after Lift Up has started, or when the Level Senser
detected Lift Up.
Lift Up cannot be performed when the Level Snr should detect Lift Up.
On: Every 4 phase H/L toggling
[T-ON]: On
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-001
[Reference BSD]: CH7.5
33. 008-003
#2Feed Motor (Fwd)
[PSW Display]: #2Feed Motor (Fwd)
[Operation Description]:
Feed (Turn #2Feed Motor On in paper feed direction at 192mm/sec)
On: -
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-004
[Reference BSD]: CH7.6
34. 008-004
#2Feed Motor (Rev)
[PSW Display]: #2Feed Motor (Rev)
[Operation Description]: Lift Up
It turns Off automatically 6sec after Lift Up has started, or when the Level Senser
detected Lift Up.
Lift Up cannot be performed when the Level Snr should detect Lift Up.
On: -
[T-ON]: On
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-003
[Reference BSD]: CH7.6
Chapter 3 Troubleshooting