Make Busy Control - Toshiba Strata CTX28 Programming Manual

Make Busy Control

When an error occurs in hardware resources used for a station or a line fails, this feature makes them busy.
The station or line PCB can be disabled temporarily to perform maintenance or parts replacements as well.
This program is only available in the telephone button programming mode.
Program Number(s): 912
Prerequisite Program:
Reference:
Access Sequence:
The Shelf number is entered in "XX" format where Shelf is a two digit value from 01~07
Note
corresponding to the Strata CTX Cabinet number. See
description of the LED display.
FB Name
Equipment
Slot #1
Slot #2
Slot #3
Slot #4
Slot #5
Slot #6
Slot #7
Slot #8
Slot #9
Slot #10
A7 A7 
1. Press ~
Access Sequence above.
Note The slot to which your programming phone is connected can not be set to Make Busy.
‚yq
2. Press to execute.
‚yq
3. Press again to return to
ÆÃÆÃ ‚yq
4. Press
5. Enter another program number to continue programming or press
mode.
Program Button LEDs
The LED blink pattern indicates the following:
• Red continuous blinking – PCB experienced a Make Busy status error.
• Red continuous illumination – PCB Make Busy Status mode is on.
• Green continuous blinking – PCB Make Busy Status mode is stand by.
• Green intermittent blinking – PCB Make Busy Status mode is idle.
Strata CTX Programming - Part 3: Telephone Button Programming 6/04
Format SmartMedia Card
None
Login to programming mode from your telephone button pad:
‚yqÃ Æ Æ ! "
At the PASSWORD= prompt, Enter your password and press
At the PROG= prompt enter
At the CABINET= prompt enter the Shelf number.
FB Summary
00 Enter Cabinet Number
01
02
03
04
!
05
Enter or
06
07
08
09
10
to enter your Make Busy selection for the appropriate Slot in the Cabinet entered in
CABINET
= prompt.
PROG
to return to the = prompt.
.
( ! ‚yq
and press .
"Program Button
Value
01~07 (value=xx)
1: Set make busy
2: Clear make busy
ÆÃÆÃ ‚yq
Telephone Button Programming
900 Series Programs
à ‚yq
.
LEDs" below for a
again to exit programming
13-109