Make Busy Control - Toshiba CTX100-S Programming Manual

FB Name
Total Blocks
Copied Blocks
Active Side Status
Stand by Side Status 05
Active Side Number
Status
Note Before running this program, make sure the SmartMedia card is properly formatted. See
Unmount SmartMedia"
)%
1. Press to enter your Backup choice. Press the
options.
 )%
2. Press .
+ROG
3. Press to execute. Press
programming mode from your telephone.

Make Busy Control

When an error occurs in hardware resources used for a station or a line fails, this feature makes them busy.
The station or line PCB can be disabled temporarily to perform maintenance or parts replacements as well.
This program is only available in the telephone button programming mode.
Program Number(s): 912
Prerequisite Program:
Reference:
Access Sequence:
Strata CTX Programming - Part 3: Telephone Button Programming 11/03
FB Summary
02 View total blocks to be updated (total blocks
will vary depending on software versions).
03 View number of blocks copied.
04 Backup Type Display
Stand by Backup Type
06 Active Side Number.
07 View Backup Status.
on page 13-103
)%
and should blink green.
+ROG
again to Cancel. This program stops running if you exit
Format SmartMedia Card
None
Login to programming mode from your telephone button pad:
+ROG    .
At the PASSWORD= prompt, Enter your password and press +ROG.
At the PROG= prompt enter  and press +ROG.
At the CABINET= prompt enter the Shelf number.
for more details.
6FUROO 3DJH
or button to view your selection
Telephone Button Programming
900 Series Programs
Value LCD Prompt
0~65536 (CTX670) n/a
0~128 (CTX100)
default = 0
0~65536 (CTX670) n/a
0~128 (CTX100)
default = 0
1:Normal 1:Normal
2:Trial 2:Trial
3:Fault 3:Fault
4:Don't Care 4:Don't Care
5:Error 5:Error
1:Normal 1:Normal
2:Trial 2:Trial
3:Fault 3:Fault
4:Don't Care 4:Don't Care
5:Error 5:Error
0 or 1 ACT SIDE=
default = 0
1:Idle 1:Idle
2:Running 2:Running
3:Success 3:Success
4:Error 4:Error
"Format/
13-107