Toshiba Strata CTX28 Programming Manual page 210

IP Telephone Programming
152 Voice Packet Configuration Table Assignment
F
IELD
02 Jitter Buffer Type
03 Jitter Buffer Length
04 Max. Acceptable Delay
05 Measurement Period
06 Packet Loss Ratio
07 Packet Loss Threshold
8-6
D
ESCRIPTION
The default values for the selected codec is recommended. If the voice quality is not
as expected you can change the jitter buffer type of DSP on BIPU.
Possible values: Fixed, Sequential, or Adaptive
The default values are: G.711 = Adaptive,
G.729A = Sequential (recommended).
The default values for the selected codec is recommended. If the voice quality is not
as expected you can change the jitter buffer length.
Possible values: 0~250
The default values are: G.711= 100msec., G.729A=40msec.
Not available in Release 2.0.
Not available in Release 2.0.
Not available in Release 2.0.
If packet loss is more than 10, an error is recorded in the CTX error log and you
cannot talk by IPT. The default value 5 is recommended.
Possible values: 0~10
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04