Series Programs; System Initialize - Toshiba Strata CTX28 Programming Manual

900 Series Programs

These programs are organized based on functions versus program numbers.

System Initialize

This program enables you to reset hardware and initializes, or restores programmed data.
Program Number(s): 900
Prerequisite Program:
Reference:
Access Sequence:
FB Name
Initialize Level 01
To access programming parameters
A7
1. Press to choose Initialize Level 1 or 2.
‚yq
2. Press twice to initialize.
Choosing Initialize Level 1 without installing a SmartMedia Card deletes all programmed
Important!
data and returns your Strata CTX to factory default settings. All previously programmed
data is lost.
Restoring Data from SmartMedia
When initializing with Level 1 you can restore custom data that was previously programmed and stored on
a SmartMedia card. To do so, follow the steps below.
1. Install a SmartMedia card that contains the
default.dat
"Data Backup"
A CTX
Important!
same or higher than the CTX software version on which the default.dat file was created.
Examples: A
MF030, MF031 and higher R2.1MG0XX, R2.2 MF0XX (XX = 01~99, but it cannot be
restored on R2.0 MF012, MF011 and lower, or R1.X ME0XX, MD0XX, etc.
2. After installing the SmartMedia card, run System Initialization using Initialize Level 1.
Restoring data from the SmartMedia card may take an hour or more. To verify completion of the restore
process access, the Programming Mode from a telephone and enter your password. If the system
enables you to continue, the data restore process is complete.
During the restore process, the telephone LCD may display date and time data. This does not
Note
necessarily indicate completion of the restore process.
Strata CTX Programming - Part 3: Telephone Button Programming 6/04
None
None
Login to programming mode from your telephone button pad:
‚yqÃ Æ Æ ! "
At the PASSWORD= prompt, Enter your password and press
At the PROG= prompt enter
FB Summary
!
Press or to select the initialize level.
Level 1 – Erases programmed data and
enters default data or backed up data if a
SmartMedia Card is installed (see Note).
Level 2 – Simulates System Power Off/Power
On operation to reset hardware.
file contains your custom settings and can be created by running Data Backup. See
on page 13-106.
default.dat
database can only be restored to a CTX software version that is the
default.dat
created on CTXR2.0 MF029 can be restored on an R2.0
.
( ‚yq
and press .
1. Initialize Level 1
2. Initialize Level 2
Prgdata
directory with the
Telephone Button Programming
900 Series Programs
à ‚yq
.
Value LCD Prompt
1:Restart with
Clear Data
2:Restart
default.dat
file. The
13-97