Toshiba Strata CTX28 Programming Manual page 454

Applications, Tips and Tricks
IPT1020-SD Telephone Network Settings
IPT-to-IP Network Connection Instructions
1. Press +
!
2. Press , then press
A7
3. Press
: manual setting, then press
!
: auto setting by DHCP server, then press
4. If Step 3 above is set for manual setting, then press
C‚yq
. To enter the period in an IP address, press the
"192.168.1.241," press
A7
5. Press
"255.255.255.0, press
6. If the IPT is connected to a router or other gateway device and if Step 3 above is set for manual setting,
then press
A7$
7. Press
number (PDN), which must be set in CTX Program 200.
A7%
8. Press
interfaces, then press
must match the IP CTX Identifier number set in Program 150-09.
A7
9. Press
: manual setting, then press
(e.g., if the BIPU IP address is "192.168.1.241," enter it in this format
!
: auto setting by broadcast, then press
: auto setting by multicast (IPT doesn't support multicast setting in this first release), then press
C‚yq
Press
10. Go off-hook and hang up. The IPT will search for the BIPU-M, initialize and then set the IP address
(from 20 sec. to 60 sec.). Time, Date and PDN displays on LCD when the information is set.
See "IP Telephone Start Up
Note
during this procedure.
A-8
% ( C‚yq
+ + (simultaneously).
C‚yqÃ
to select the Network Setting Mode.
to see if the DHCP server is in use or not. Press one of the following:
C‚yq
(! %'

. Enter the subnet mask number and press
!$$ !$$

A7#
. Enter the router address, then press
. Enter a Station ID for the IPT and press
to enter the node number of the CTX node that contains the BIPU-M to which this IPT
C‚yq
. This FB setting is for CTX networked systems only. This node number
for BIPU IP address mode. Press one of the following:
C‚yq
again to set all the above data.
Sequence"below for an explanation of the LCDs that you will see
.
C‚yq
.
A7!
. Enter the IP address for this IPT and press
button on your dialpad (e.g., if the IP address is

!#
).
 
C‚yq
!$$ 
).
 
C‚yq
C‚yq
A7 !
. Press and enter the BIPU IP address, then press
C‚yq
.
. (e.g., if the subnet mask address is
.
. This is usually your telephone's primary
(! %'
  
Strata CTX Programming - Part 4: Appendices 6/04
C‚yq
.
!#
).
C‚yq
.