Toshiba Strata CTX28 Programming Manual page 118

Station
Assignment
F
IELD
19 VMID Code SMDI
22 MW to VM Port
23 Travelling COS
Change
24 TGAC Override
25 Service Tones
26 CW and ROB Tone
27 Name Display
28 Door Ovr DND
30 Chg Sys Speed
31 Network COS
32 Auto OCA
33 Originate OCA
5-4
D
ESCRIPTION
Enter the voice mail box number that should answer calls when this PDN calls
voice mail; or, when this PDN is called and then forwards to voice mail (this number
is prefixed by codes in Program 579, 11~16)
Possible values: Digits 0~9, * and #, up to 10 characters (default = no value).
Note This VMID code is sent to the voice mail device in SMDI packets or DTMF
tones on direct calls to voice mail from the PDN; and on calls to the PDN
that forward to voice mail. See Program 580 for SMDI or DTMF choice.
Enter the Message Waiting center DN. For Remote CTXs, assign message center
including Node IP for TPI integration. This parameter enables Call Record function
too.
Possible values: Up to 7 ASCII characters (default = no value)
Enable this station with the privilege to change the Travelling COS Override Code.
Possible values: Enable or Disable (default)
1
Enable Trunk Group Access Code (TGAC) override (for Attendant console) from
this station.
Possible values: Enable or Disable (default)
Disable Service Tone for Data Privacy.
Possible values: Enable (default) or Disable
Note Service tone such as Call Waiting should be disabled for modems, faxes,
and similar devices.
Enable/Disable the station to receive Call Waiting (Campon) and Ring Over Busy
Tone.
Possible values: Enable (default) or Disable
Notes
•
CW tone is always two beeps.
•
ROB tone can be two beeps or continuous as set in PRG 204, 27.
Enable this station with the privilege to put the user name in the Directory
Assistance display of a large LCD.
Possible values: Enable (default) or Disable
Enable DND override by door phone.
Possible values: Override or Do not Override (default)
Enable this parameter to program System Speed Dial.
Possible values: Enable or Disable (default)
Select Network COS value.
Possible values: 1~32 (default = 1)
OCA occurs automatically when making a call to a busy station that allows OCA
calls to be received.
Possible values: Enable or Disable (default = Enable)
Enable this station with the privilege to make OCA calls to other stations.
Possible values: Enable (default) or Disable
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04