Toshiba Strata CTX28 Programming Manual page 361

Table 13-16 Programs 203~204 (continued)
Button Sequence
204-27 Ring Over Busy
Cycles
A7!& C‚yq
, n,
204-28 Attd Overflow Dest.
A7!' C‚yq
, n,
204-29 Trunk Test and Verify
A7!( C‚yq
, n,
204-30 Auto Line Hold
A7" C‚yq
, n,
204-31 Call Progress
Dependency
A7" C‚yq C‚yq
, n, ,
Strata CTX Programming - Part 3: Telephone Button Programming 6/04
Value(s)
n = 1. Two Cycles
2. Continuous
n = Up to 32 digits
n = 1. Yes
2. No
n = 1. Enable
2. Disable
n = 1. Terminal Mode
2. Line Mode (default)
Telephone Button Programming
Summary
Set ROB to ring two times or continuously.
Note See PRG200, 26 to enable ROB to be sent to individual
telephones.
Select overflow destination for attendant.
Allow Trunk Tests and Verification.
Enable Automatic Line Hold. This parameter allows a station to "line
hop" from one call to another automatically by placing the first call on
hold.
Allows the telephone to be set to ring or not ring when busy on a call.
If a telephone has multiple DNs (PDN + PhDNs), set this parameter to
the Line Mode.
Terminal Mode: Callers will receive busy tone when any DN or CO
line button on the telephone is in-use. If Call Forward Busy/No
Answer is set on the telephone a call to the telephone will forward
immediately when a call is delivered while the user is talking on any
DN or CO line button.
Line Mode: Calls will ring the telephone when the user is talking on a
line or DN button if the telephone has multiple DN or line buttons in a
hunt configuration. If Call Forward Busy/No Answer is set, the
telephone will Ring No Answer and then forward when a call is
delivered to the telephone while the user is talking on a DN or CO line
button.
200 Series Programs
13-37