Toshiba Strata CTX28 Programming Manual page 342

Telephone Button Programming
100 Series Programs
Table 13-5 Programs 103~107 (continued)
Button Sequence
104-14 Emergency Call Timer
A7 # C‚yq C‚yq
, n,
104-15 ABR Busy Detection
Time
A7 $ C‚yq C‚yq
, n,
104-16 Lost Call Timer
A7 % C‚yq C‚yq
, n,
104-17 Lost Call Final Timer
A7 & C‚yq C‚yq
, n,
104-18 DTMF Tone Sending
Time
A7 ' C‚yq C‚yq
, n,
104-19 Auto Disconnect
A7 ( C‚yq C‚yq
, n,
104-23 System Timer
Network DSS Refresh
Timer
104-24 Outgoing Number
Display Timer
105 System Parameters
$ C‚yq
,
105-01 Executive Override
A7 C‚yq
, n,
105-02 Station MOH
A7! C‚yq
, n,
105-03 Ringing Transfer
A7" C‚yq
, n,
105-04 Transfer Privacy
A7# C‚yq
, n,
105-05 Privacy Override
A7$ C‚yq
, n,
13-18
Value(s)
n = 10~180 sec.
(default = 30)
n = 1~30 sec.
(default = 5)
n = 1~600 sec.
(default = 180)
n = 1~600 sec.
(default = 180)
n = 1. 80 ms (default)
2. 160 ms
n = 0~60 sec.
(default = 0)
n = 20~180 sec. (default = 30)
n = 1~120 sec. (default = 10)
n = 1. Enable (default)
2. Disable
C‚yq
,
n = 1. Quiet Tone
2. External 1 (default)
C‚yq
,
3. External 2
4. External 3
5. External 4
6. External 5
7. External 6
8. External 7
9. External 8
10. External 9
11. External 10
12. External 11
13. External 12
14. External 13
15. External 14
16. External 15
n = 1. RBT (default)
2. MOH
C‚yq
,
n = 1. Enable (default)
2. Disable
C‚yq
,
n = 1. Enable
2. Disable (default)
C‚yq
,
The Emergency Call timer sets a time (10 ~ 180 seconds) for
advancing the call to the next station in a list of destinations for the
call.
The Destination Busy Detection timer sets the time (1 ~ 30 seconds)
to wait while looking for a busy condition on an external call. If
detected, it will trigger the initiation of the Automatic Busy Redial
cycle.
The Lost Call timer sets the time (1 ~ 600 seconds) that a failed
transfer recall will ring on the originating station prior to attempting to
recall a secondary location.
The Lost Call Final timer sets the time (1 ~ 600 seconds) that a failed
transfer recall will ring on the secondary location before being
automatically disconnected.
The DTMF tone sending duration (1-80 msecs, 2-160 msecs) for
dialing on CO Lines.
Time after which an unsupervised trunk may be automatically
released.
Select Network DSS Refresh Timer (20 -180 seconds). The time
interval when all Network DSS settings are refreshed system wide.
Note DSS button LEDs change state immediately when the status
of the DSS button changes - regardless of this timer value.
This timer sets how long dialed numbers will display on telephone
LCDs for outgoing line calls.
This command assigns the system parameters.
Break in warning tone of Executive Override Enable or Disable.
Music On Hold selection of Private Line and Station.
Tones for the transferred party after the ringing transfer takes place.
Transfer Privacy enabled: CO line buttons that have multiple
appearances will only flash and ring on the transferred-to telephone;
the same CO line button on other telephones will be red-busy.
Transfer Privacy Disabled: CO line buttons that have multiple
appearances will flash and ring on all telephones that have the CO
line button appearance.
Privacy Override Attendant Monitor warning Enable or Disable.
Strata CTX Programming - Part 3: Telephone Button Programming 6/04
Summary