Toshiba Strata CTX28 Programming Manual page 263

From CTX Attendant Console Set up BLF Network
Step 2:
Complete Step
Important!
page 9-46
1. Click Administration view.
2. Select the BLF Network Control
tab.
3. Enter the IP addresses of primary
and remote CTXs.
4. Enter the Port Number (6000).
5. In the Name field, enter the Node
Identified. For example, names
such as Dallas, Chicago, etc.,
depending on where the remote
CTXs are located.
6. Enter the Refresh rate. This is the
frequency that the software will
poll the remote site.
7. Click Add.
8. Enter the data for the other nodes,
then click OK.
Notes
•
When you make the directory in the CTX Attendant Console and when entering user information, add
the Node ID as prefix to the extension.
•
When you start the CTX Attendant Console for the first time, a dialog box appears that requires the IP
addresses and Port numbers of each CTX.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
1:"Program Network BLF from WinAdmin for CTX Attendant Console"
before you begin the following steps.
Network Busy Lamp Field (BLF) (R1.3 and higher)
Services
on
6599
9-47