Ctx Restart - Toshiba Strata CTX28 Programming Manual

Operation
System Setup

900 CTX Restart

Prerequisite Program:
This program enables you to reset hardware and initializes or restores programmed data.
CAUTION!
F
IELD
Restart CTX
Initialize CTX
Important!
Restoring Data from SmartMedia
When initializing with Initialize CTX, you can restore custom data that was previously programmed and
stored on a SmartMedia card. To do so, follow the steps below.
1. Insert a SmartMedia card that contains the Progdata folder with the default.dat file. The default.dat
file contains your custom settings and can be created by running Data Backup. See
on page 10-13.
2. Run System Initialization by clicking Initialize CTX.
Notes
•
Restoring data from the SmartMedia card may take an hour or more.
•
During the restore process, the telephone LCD may display date and time data. This does not
necessarily indicate completion of the restore process.
•
To verify completion of the restore process access the Programming Mode from a telephone and enter
your password. If the system enables you to continue, the data restore process is complete.
3. Remove the SmartMedia card and restart the CTX again after restoring system data. This is necessary
to reset BIBU-M, BIPU-Q, QSIG, ISDN and other advanced features.
10-2
None
Both commands will drop all existing calls.
D
ESCRIPTION
Clicking on this button initializes a System Power Off/Power On sequence to reset
hardware. This is also known as an Initialize Level 2.
Clicking on this button invokes an Initialize Level 1 sequence which erases
programmed data and enters default data into the Strata CTX System.
If a Toshiba SmartMedia is installed in the available slot, using this option restores
data from backed up data from the SmartMedia (see
SmartMedia below).
Choosing Initialize CTX without installing a SmartMedia Card deletes all programmed data
and returns your Strata CTX to factory default settings. All previously programmed data is
lost (See "Restoring Data from SmartMedia" on page 10-2).
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
Restoring Data from
"910 Data Backup"