Network Jack Lan Device Assignment - Toshiba Strata CTX28 Programming Manual

801 Network Jack LAN Device Assignment

Prerequisite Program:
This screen assigns Strata CTX LAN
parameters, enabling PC applications
to connect to the BECU network jack.
1. From the Program Menu click
System > I/O Device. The
Equipment Assignment screen
displays.
2. Click the LAN Device tab. 801
Network Jack LAN Device
Assignments screen displays
(shown right).
3. Enter Program 801 data.
F
IELD
00 LAN Port Number
01 Protocol
02 PC Operation Type
03 Data Flow
04 Server Port Number
05~08 Client IP
Address
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
803 on page 4-31 and 804 on
D
ESCRIPTION
Enter the port number of the LAN device to be assigned. Refer to
Port Assignments" on page
Possible values: 1~12 (default = no value)
Notes
•
Program the local port number for LCD Control of Voice Mail
•
Use the same Device Port No. (11) for Network BLF.
•
Use 10 for Network TPI
•
Use 12 for Network DSS
•
Network BLF and DSS are available only with CTX Release 1.3 or higher software
and with CTX WinAdmin Release 1.3 or higher software.
Select communication Protocol.
Possible values: TCP (default) or UDP
Note Select UDP for Network DSS.
Select the Operation Type.
•
If Server is selected, enter 04 Server Port Number.
•
If Client is selected, enter the 05 Client IP Address.
Possible values: Server (default) or Client
Note Select Client for TPI.
Select the data flow protocol for CTX and PC communications.
Note If the logical device set up in
page 4-31 is set to CTI, this field must be set to Asynchronous data flow.
Possible values: Synchronization or Asynchronization (default = Asynchronization)
Enter the Server Port Number and proceed to 07 Read Retry Number. This field is
required if Server was selected in 02 PC Operation Type above. If not, leave this field
blank and proceed to 05 Client IP Address.
Possible values: 0~65535 (default = 0)
Note Use 6000 for Network BLF, 3000 for Network DSS and 5000 for Network TPI.
Enter the Client LAN IP Address. This field is required if Client was selected in 02 PC
Operation Type above.
Possible values: 0~255 for each octet (default = 0)
Note Enter IP address of Stratagy iES32 or SES.
page 4-34.
4-31.
"803 SMDR SMDI CTI Port Assignments"
System
I/O Device
6538
"803 SMDR SMDI CTI
on
4-33