Trunk Assignment - Toshiba Strata CTX28 Programming Manual

Trunks

300 Trunk Assignment

F
IELD
17 QSIG Sending Type
18 Network COS
19 Recall on AC15
300 Trunk Assignment
Prerequisite Program:
Assigns an analog or T1 trunk (line) and its parameters to the system. Click on each tab to navigate through
the programs. The trunks assigned to the equipment display on the left of the screen. The first column
displays the trunks used and the second column displays the equipment. You can also sort based on trunks
and equipment.
Important!
1. Complete the
Record Sheet"
2. From the Program Menu, click
Trunk > Assignment. The Trunk
Basic Assignments screen displays
(shown right).
3. Enter a Trunk Number
...or click one of the following
buttons:
• List – view a summary list of
programmed Trunks.
• Create – Assign a new Trunk
with default settings.
• Copy – Enter an Trunk Number and click Copy to make a new Trunk assignment with settings
copied from the OLG entered in Group Number.
• Delete – Delete an Trunk.
4. Enter Trunk Assignment Data.
5. Click Submit.
6. Click the Go Timer/DIT link to view Programs 308 and 310 (see
details).
6-6
D
ESCRIPTION
Digit sending Mode for QSIG only.
Possible values: Cut Through or Senderized (default = Cut through)
Select Network COS number.
Possible values: 1~32 (default = 1)
This enables or disables the sending and detection of a recall signal on AC15 TIE
lines. (This applies to the PACU PCBs only.)
100 page 4-1
You must have Internet Explorer (IE) 6.0 on your PC for the sort to work correctly. If you
have IE 5.0, you can upgrade to IE 6.0 using the Strata CTX CD-ROM. IE 6.0 does not auto-
install from the CD-ROM; run ie6setup.exe from the IE 6.0 folder on the CD-ROM.
"Trunk Assignment
on page D-23.
"308 Trunk Timer"
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
on page 6-10 for