Toshiba Strata CTX28 Programming Manual page 26

Strata CTX Programming Guidelines
Step 1: Use Default Auto-programming to Start Up
Table 1-7 IPT Automatic Settings
Item
DN Setting
Accommodated terminal setting
(Station ID)
Accommodated terminal setting
(IP Address)
Accommodated terminal setting
(MAC addresses)
Table 1-8 System Related Basic Settings
Item
QOS Control
Station ID
Terminal authentication setting
BIPU-Q1A Initial Programming
After initializing the CTX System with BIPU for Strata Net over IP, Strata CTX detects the BIPU card for
Strata Net over IP and basic programming is set automatically.
Table 1-9 BIPU-Q1A Automatic Settings
Item
Card Type
IP Address (BIPU)
Subnet mask (BIPU)
Default gateway
1-6
Description
DN setting of the terminal
accommodated in BIPU
Parameter setting of Station
ID in BIPU
Parameter setting of IP
address in BIPU
Parameter setting of MAC
addresses in BIPU
Description
Setting of priority control by
Diffserv/IEEE802.1p
Automatic setting of Station
ID
Application or non application
of connection restriction
function using MAC address
Description
Card Type
IP address of BIPU-Q1A
Subnet mask of BIPU-Q1A
Default gateway of BIPU-Q1A 0.0.0.0
Settings
The number plan conforms to BDKU16.
Assigned in the order of the lowest slot
number.
Station ID = PDN
IP address = 0.0.0.0
MAC addresses = (no data)
Settings
Use of Diffserv: Not applicable
Set value of DSField = 0
Use of IEEE802.1p: Not applicable
Priority level: Voice
Not allowed
Not apply
Settings
BIPU-Q1A
In the order of smallest number of the slot
where BIPU is inserted
192.168.254.800 for 1st BIPU
.801 for 2nd BIPU
.802 for 3rd BIPU
Private address will be set.
255.255.255.0
Strata CTX Programming - Part 1: Getting Started 6/04