Step 2D: Set Up Ip Address Of Ctx Winadmin Pc Nic (Windows 2000) - Toshiba Strata CTX28 Programming Manual

Step 2D: Set Up IP Address of CTX WinAdmin PC NIC
(Windows 2000)
Follow the steps below to set up PC Network settings on your WinAdmin PC.
This setup is only for direct connection to the Strata CTX or for simple Hub or LAN connections.
Note
For more complex LAN, WAN or Internet connections, refer to
Internet Connections" on page
1. Click Start > Settings > Network and Dial-up
Connections > Local Area Connections.
2. Right click on Local Area Connections to select
Properties.
3. Local Area Connection Properties Connection screen
displays. Ensure Internet Protocol
(TCP/IP) is checked. Highlight TCP/IP, then click the
Properties button.
4. On the General tab click the "Use the following IP
Address" radio button (shown right).
5. In the IP address field enter
where
a.b.c = 0~255
Example: 192.168.254.x.
The first three octets a.b.c. have to be exactly the same
as the first three octets of the CTX IP address set in
step 7 of Step 2B. x cannot be 253 or above and it
cannot be equal to octet d of the CTX TCP/IP address
set in Sub-step 7
e.f.g.h
6. Enter
Subnet Mask set in
Possible Values of Subnet mask octets e.f.g.h = 0~255
Example: 255.255.255.0
7. Leave the DNS Server addresses blank.
8. Click OK (to accept all screens).
9. Go to "Step 1: Install CTX WinAdmin Software" on page
CTX WinAdmin is now ready to communicate and program your Strata CTX System.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
3-5.
a.b.c.x
and x
= 0~252.
of Step 2B. This is the static IP Address of your PC.
. in the Subnet Mask field. The Subnet Mask should be exactly the same as the CTX
Sub-step 9 of Step 2B.
Set Up LAN Connection to Strata CTX
"Wide Area Networks and/or
Sub-
3-14.
Installation
3-9