Toshiba Strata CTX28 Programming Manual page 460

Applications, Tips and Tricks
Strata Net over IP Programming Guidelines
To program the configuration in the above figure using programs 671 and 672
The steps below show you how to setup Node 11 to route to remote Nodes 12 and 13.
1. With WinAdmin connected to Node 11, go to Program 672 (Services > Networking > Network Over
IP > Detail Info tab). Parameters for all Remote Nodes connected to Node 11 are pre-set in this
program.
2. Select Node 12 and verify all parameters are set to defaults.
3. Select Node 13 and verify all parameters are set to defaults.
4. With WinAdmin connected to Node 11, go to Program 671 (Services > Networking > Network Over
IP > IP Route tab). The IP addresses of BIPU-Qs connected to Node 11 are set in this program.
5. Select Node 12 and enter its BIPU-Q IP address (192.168.12.101) into IP Address Route 1.
6. Select Node 13 and enter its BIPU-Q IP address (192.168.13.102) into IP Address Route 1.
Notes
The IP addresses used in this example are only examples, check with the facility network
administrator for the IP addresses that should be used in your installation.
If a remote node has more than one BIPU-Q installed, its IP address would be entered in Route 2.
A maximum of six remote BIPU-Qs can be assigned in each remote node. Route 1 will be used
until all channels are busy, or not working, in which case Routes 2~6 will be used in sequentially.
7. Repeat Steps 1~6 with WinAdmin connected to Node 12 to set up Remote Nodes 11 and 13.
8. Repeat Steps 1~6 with WinAdmin connected to Node 13 to set up Remote Nodes 11 and 12.
A-14
Strata CTX Programming - Part 4: Appendices 6/04