Replacing The Tray 2 Feed Roller/Tray 2 Pick-Up Roller - Konica Minolta bizhub C353 Service Manual

3. Periodical check
3.4.7

Replacing the tray 2 feed roller/tray 2 pick-up roller

A. Periodically replacing parts/cycle
• Tray 2 feed roller: Every 300,000 prints
• Tray 2 pick-up roller: Every 300,000 prints
B. Procedure
1. Slide out the tray 2.
2. Remove the vertical transport door.
See P.92
3. Remove the rear right cover /3.
See P.90
[2]
[1]
[2] [3]
[1]
26
[1]
[2]
A02EF2C015DA
A02EF2C016DA
[2]
A02EF2C017DA
Field Service Ver. 4.0 Jun. 2008
4. Remove the harness cover [1], and
disconnect the connector [2].
5. Remove four screws [1], and remove
the tray 2 paper feed assy [2].
NOTE
• The tray 2 paper feed assy is posi-
tioned by the shaft that passes
through the back frame of the assy.
When removing the tray 2 paper
feed assy, slide it in the direction of
the arrow.
6. Lower the jam clearing cover [1],
remove two screws [2], and remove
the tray 2 separation roller assy [3].