Konica Minolta bizhub C353 Service Manual page 470

Field Service Ver. 4.0 Jun. 2008
C. JPEG check
• This function is available only when the optional scan accelerator kit (SA-501) is
mounted.
Functions • This function enables you to check whether image data are compressed properly
through the scan accelerator kit (SA-501).
Use • When a copy image problem occurs, you can refer to JPEG check.
Adjustment 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] →
Procedure
[JPEG check].
3. Pressing the Start key will automatically start to complete a JPEG check sequence.
4. The check result will be displayed.
D. Memory Bus Check
Functions • To check to see if image data is correctly transferred from scanner to memory, and
from memory to printer.
Use • If the copy image is faulty.
Adjustment 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] →
Procedure
[Memory Bus Check].
3. Select either [Scanner → Memory], [Memory → PRT], or both.
4. Pressing the Start key will start the memory bus check and be terminated automati-
cally.
5. The check result will be displayed, [OK] or [NG].
E. Work Memory In/Out Check
Functions • To check to see if input and output of image data of work memory are correctly per-
formed.
Use • If the print image is faulty.
Adjustment 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [Work
Procedure
Memory In/Out Check].
3. Select either [Input Check], [Output Check], or both.
4. Pressing the Start key will start the work memory input/output operation check
sequence and be terminated automatically.
5. The check result will be displayed, [OK] or [NG].
F. HDD Version Upgrade (LK)
2
• This is displayed only when the function enhanced version 2 or later firmware is installed.
Functions • To maintain the compatibility of management information data and documents stored
in HDD after the firmware upgrade.
Use • This must be performed after upgrading the firmware to the function enhanced ver-
sion 2.
Adjustment 1. Call the Service Mode to the screen.
2. Touch [State Confirmation] → [Memory/HDD Adj.] → [HDD Version Upgrade (LK)].
Procedure
3. Touch Start key to initiate upgrading the current HDD version.
4. When the upgrade is completed, the result is displayed on the screen.
NOTE
• Make sure to turn OFF the main power switch when firmware upgrade is com-
pleted, and turn it ON again more than 10 seconds after.
10. Service Mode
425
2