Konica Minolta bizhub C353 Service Manual page 471

10. Service Mode
G. Down Ver.
• This is displayed only when the function enhanced version 3 or later firmware is installed.
Functions
• In the process of firmware downgrade from the function enhanced version 3 firmware
3
Use
Adjustment • For the details about how to use this function, see "Firmware upgrade."
Procedure See P.48
H. HDD Version Up
Functions
• To upgrade administration data (Document management information, address infor-
Use
Adjustment 1. Open the Service Mode.
Procedure 2. Set the following setting.
3. Touch the Start key to start upgrading the version.
4. When upgrading the version is complete, the outcome will be displayed on the
NOTE
• Make sure to turn main power switch OFF when upgrading is complete, and
I. HDD R/W Check
Functions • To check to see if the hard disk is connected properly, and if read/write operation of
Use • When the hard disk is mounted.
Adjustment 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [HDD
Procedure
3. Pressing the Start key will start the hard disk R/W check sequence and be termi-
4. The check result will be displayed, [OK] or [NG].
426
3
to the function enhanced version 2, use this function before rewriting the firmware.
mation, etc.) other than image data in HDD.
[State Confirmation] → [Memory/HDD Adj.] → [HDD Version Up]
screen.
wait for ten seconds to turn back ON.
the hard disk is correctly performed.
R/W Check].
nated automatically.
Field Service Ver. 4.0 Jun. 2008