Konica Minolta bizhub C353 Service Manual page 838

Field Service Ver. 2.0 Jan. 2008
[1]
[1]
11. Perform another test print and check the reference deviation.
12. Repeat the adjustment until the reference line falls within the specified range.
13. Tighten the adjustment screw.
14. Repeat steps 1 to 13 similarly for the tray 4.
15. Touch [END].
16. Touch [Exit] on the Service Mode screen.
17. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
[2]
A093F3C502DA
[2]
A093F3C503DA
6. Mechanical adjustment
8. Slide out the drawer [1] and unload
paper from it.
9. Loosen three screws [2] at the center
of the paper lifting plate.
10. Watching the graduations [1] pro-
vided in the drawer, move the edge
guide [2] in the rear.
• If width A is greater than the specified
value, move the edge guide toward the
front.
• If width A is smaller than the specified
value, move the edge guide toward the
rear.
21