Stabilizer - Konica Minolta bizhub C353 Service Manual

10. Service Mode
B. Secondary transfer adj.
Functions • Adjust the 2nd image transfer output (ATVC) on the 1st page and the 2nd page for
each paper type.
Use • To use when the transfer failure at the trailing edge occurs.
Adjustment • The default setting is 0.
Range
Adjustment To increase the ATVC value (in the direction of a foggier image),
Instructions increase the setting value.
To decrease the ATVC value (in the direction of a less foggy image),
decrease the setting value.
Setting/ 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [Imaging Process Adjustment] → [Transfer Output
Procedure
Fine Adjustment].
3. Select [Secondary transfer adj.].
4. Select the side of the image (1st side or 2nd side), on which the transfer failure
occurs.
NOTE
• For envelopes, only first side can be selected.
5. Select the paper type with the transfer failure.
6. Enter the new setting from the [+] / [-] keys.
7. Touch [END] to validate the adjustment value.
8. Check the print image for any image problem.
10.6.6

Stabilizer

A. Stabilization Only
Functions • The image stabilization sequence is carried out without clearing the historical data of
image stabilization control.
Use • Use if an image problem persists even after gradation adjustment has been exe-
cuted.
• When [D Max Density] and [Background Voltage Margin] of Service Mode are
changed.
Setting/ 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [Imaging Process Adjustment] → [Stabilization Only].
Procedure
3. Press the Start key to start Stabilizer.
The Start key turns red and stays lit up red during the Stabilizer sequence.
4. Stabilizer is completed when the Start key turns blue.
366
Field Service Ver. 4.0 Jun. 2008
-8 to +7 (step: 1)