Konica Minolta bizhub C353 Service Manual page 255

8. Utility Mode
(2) Sleep Mode Settings
Functions • To set the time until sleep mode starts operating after the last key operation has been
• Turn all lines OFF except 5 V line for control.
• "OFF" will only be displayed when [No Sleep] in Service Mode is set.
Use • To change the time until the sleep mode starts.
Setting/ • Use the 10-key pad for setting.
Procedure • The default setting is 20 min.
F. Output Settings
• It will be displayed only when the following setting is set to "Level 2."
[Administrator Settings] → [Security Settings] → [Administrator Security Levels]
• It will not be displayed when the following setting shows that authentication device or the
vendor is mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
(It will be displayed when the key counter is mounted.)
(1) Print/Fax Output Settings
Functions • To set the timing for printing for the PC print job or fax received.
Use
Setting/ <Printer>
Procedure • The default setting is Page Print.
<Fax>
• The default setting is Batch Print.
NOTE
• [FAX] will be displayed only when the optional fax kit (FK-502) is mounted.
(2) Output Tray Settings
• It will be displayed only when the optional finisher FS-509 or job separator JS-505 is
1
mounted.
<When the FS-519 is mounted>
Functions • To set the priority output tray for each application (Copy print, Printer, Fax and Print
Use • To change the prior output tray according to the application.
Setting/ • The default settings are as follows.
Procedure
210
1
completed.
Batch Print : Starts printing when all data are received
Page Print : Starts printing every time data for each page are received
Reports).
Copy : Tray 1 (Tray 3: When [Bin Setting] is enabled.)
Print : Tray 1
Report Output : Tray 2 (Tray 3: When the optional OT-602 is mounted./When
Fax : Tray 2 (Tray 3: When the optional OT-602 is mounted./When
Field Service Ver. 4.0 Jun. 2008
"20 min." (2 to 240) / OFF
[Bin Setting] is enabled.)
[Bin Setting] is enabled.)