Scan Caribration; Lct Paper Size Setting - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 4.0 Jun. 2008
(3) Printing on paper of nonstandard size fed from the bypass tray (AnySize mode)
3
• This function is available only when the function enhanced version 3 or later firmware is
installed.
Functions • To enable printing only by the setting made on the printer driver when printing is
attempted on paper of nonstandard size fed by way of the bypass tray (the default
Use
setting is the conventional operation).
bit0-0: Conventional operation
bit0-1: The print cycle is initiated for the paper specified on the printer driver
Setting/ 1. Touch [Software Switch Setting].
Procedure 2. Touch [Switch No.] and enter "69" with the ten-key pad.
3. Touch [BIT Assignment] and select "bit2" with [←]/[→] key.
4. Enter "0" or "1" with the 10-key pad.
5. Touch [Fix].
10.9.7

Scan Caribration

Functions • To set whether to use the calibration adjustment value set prior to the shipping.
Use • To be used when CCD unit has been changed.
After replacing the CCD unit, the default value needs to be set since the calibration
value set for each unit changes to control the differences in reading performance on
each scanner (CCD).
• The original calibration adjustment value can be disabled to address image failure
and other problems caused by individual CCD performance difference.
Setting/ • The default setting is ON.
Procedure
NOTE
• When the setting is changed, the function becomes available by turning the
sub power switch OFF and ON again.
10.9.8

LCT Paper Size Setting

Functions • To set the paper size for the LCT.
Use • Use to change the paper size for the LCT (PC-405).
Setting/ • The default setting depends on the setting made for the applicable marketing area.
Procedure
regardless of the bypass tray paper setting.
"ON"
A4
10. Service Mode
OFF
8 / x 11
1
2
399
3