14. Mechanical adjustment
14.2 Mechanical adjustment of the paper feed section
14.2.1
Skew adjustment of the tray 1, 2
This adjustment must be made in the following case:
• To reduce paper skew that cannot be corrected by the registration loop adjust-
ment when the tray 1 or 2 is within the specifications.
1. Pull out the tray where this adjustment is made.
[1]
[1]
458
2. Load the tray with the paper.
3. Move the set of the paper guides [1]
A02EF2C525DA
4. Remove the paper from the tray.
5. Secure the set of paper guides [1] on
A00KF3C513DA
Field Service Ver. 4.0 Jun. 2008
until no gap is produced between the
both ends of paper and the paper
guides.
the tray using a screw (M3 x 8 mm:
V121 0308 04).