Konica Minolta bizhub C353 Service Manual page 295

8. Utility Mode
<Detection While Feeding Setting>
Functions • To set the operation for detection and removing operation of stain on the ADF original
glass when feeding the original.
Use • Use when changing the operation for detection and removing operation of stain on
the ADF original glass when feeding the original.
0
1
2
3 to 6
NOTE
• When this function is used, an image quality problem might be occurred in the
side effect by the image processing control according to the dirt condition of
the original glass.
• When the following setting is set to "0" or "1", the range which the administrator can
set will be restricted to "0 (Disable)" or "1 (Enable)."
[Service mode] → [System 2] → [Split Line Detect. Setting] → [Paper Passaging
Detection]
Setting/ • The default setting is 1.
Procedure
H. List/Counter
(1) Management List
• It will not be displayed when the following setting shows that vendor is mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
(It will be displayed when the Key counter is mounted or when the following setting shows
that switch No.33 is set to [01] at HEX assignment.
[Service Mode] → [System 2] → [Software Switch Setting])
<Job Settings List>
Functions
• To output the value set by the setting menu.
Use
Setting/ 1. Touch [Job Settings List].
Procedure 2. Select the feed tray.
3. Select simplex or duplex print, and touch the Start key.
(2) Paper Size/Type Counter
Functions
• To register the combination of the specific paper size and the paper type, and to set
the count.
Use
Setting/ 1. Press a key out of 1 to 10 registration keys.
Procedure 2. Select the paper type.
3. Touch the paper size key to select the paper size.
250
: The glass will stop moving when the original is fed, and will not perform
removing the stain.
: The glass will move between originals when feeding the original.
: When the original is fed, the glass will move while reading the original in
order to remove the stain, and reduce the lines.
: When the original is fed, the glass will move while reading the original in
order to remove the stain. The lines will be reduced also by the image
process control.
The level 3, 4, 5, and 6 of the image process are set in this order with 3
being the most efficient in reducing the lines.
Field Service Ver. 4.0 Jun. 2008
0 to 6