Konica Minolta bizhub C353 Service Manual page 772

Field Service Ver. 2.0 Jan. 2008
[2]
[1]
NOTE
• Be sure to perform the following operation when the document width detection
variable resistor is replaced.
6. Perform document width detection adjustment.
See P.32
7. Turn OFF the main power switch and turn it ON again and check whether size detection
operates normally.
3. Use two screws [1] to install the doc-
ument width detection variable resis-
tor [2].
NOTE
• Install the gear and rack gear by
aligning the arrows.
4. Connect the connector.
5. Install the document width detection
variable resistor cover and turn on
the main power switch.
9J07F2C534DA
4. Other
23