Sony HDW-750 Maintenance Manual page 523

A002 : CAPSTAN DELAY
Adjusts the capstan add-on recording.
A working tape is required for this adjustment. Use the center posi-
tion, which is at about 20 to 25 minute position of a BCT-40HD
cassette tape.
n
You can check that a working tape is at about the 20-minute position
as follows:
. The 4 black square indicators "
indication area on the display window/inside panel.
. The message "15-20" appears in the remaining tape indication area
on VF.
1. Select "A002 : CAPSTAN DELAY" on the SERVO ADJUST
MENU display and press the rotary encoder.
2. Press the rotary encoder again. The cassette lid opens automatical-
ly.
3. When a working tape is inserted, the adjustment starts automati-
cally.
4. The adjustment ends. (The adjustment data is automatically saved
in the servo system EEPROM (IC403/MDC-13 board)). A
working tape is ejected automatically.
When adjustment ends successfully :
The message "COMPLETE" appears.
When the adjustment fails :
The message "INCOMPLETE" appears.
m
When the adjustment fails, the message "INCOMPLETE"
appears, check the following possible causes and then perform
A002 : CAPSAN DELAY adjustment again.
. Tape run is abnormal or the tape is damaged.
. Tension of the timing belt needs adjustment.
Refer to the following sections for adjusting the tension of the
timing belt.
8-1-3. FWD Holdback Tension Adjustment
8-1-4. REV Holdback Tension Adjustment
8-1-5. Timing Belt Tension Adjustment
HDW-750/750CE V1
" turn on in the remaining tape
11-3. Contents of Menus
SERVO ADJUST MENU
A000:NV-RAM INITIALIZE
A001:CAPSTAN FG DUTY
A002:CAPSTAN DELAY
A003:DRUM PHASE
SERVO ADJUST MENU
A002:CAPSTAN DELAY
INSERT WORK TAPE
SERVO ADJUST MENU
A002:CAPSTAN DELAY
COMPLETE
11-21