Sony HDW-750 Maintenance Manual page 189

MANUAL RPN Display (Adjusting the DC value of the RP-123/RP-127 board)
O
? 07 MANUAL RPN
OUTPUT SELECT
RPN CURSOR
TEST OUT MENU
CURSOR H POS.
CURSOR V POS.
RECORD RPN
FIELD/FRAME
Item
OUTPUT SELECT
RPN CURSOR
TEST OUT MENU
CURSOR H POS.
CURSOR V POS.
RECORD RPN
FIELD/FRAME
*1 : RGB can be selected only when the Camcorder is used in the service mode.
HDW-750/750CE V1
: Y
: OFF
: OFF
: 0
: 0
: EXEC
: FIELD
Setting Function
*1
Y/R/G/B/RGB Selects the video signal that is output from the TEST OUT
and the VBS/SDI OUT terminal.
(The Y-signal becomes the VBS signal when the REAR
BNC OUT SEL of the OUTPUT SEL display (of the
OPERATION menu) selects the VBS position and when
the TEST OUT SELECT chooses the SD position.)
The output signal returns to the Y-signal without fail at
power-on.
OFF/ON Turns ON/OFF the cursor for RPN.
OFF/ON Turns ON/OFF the function to mix the menu display in the
output signal of the TEST OUT terminal.
_480 to 479 Sets the position of the RPN cursor. (Horizontal direction)
_270 to 269 Sets the position of the RPN cursor. (Vertical direction)
Press the rotary encoder Registers the RPN data of the present cursor position.
to execute this menu item.
FIELD/FRAME Sets the CCD read-out system.
FIELD : Field reading-out (normal readout)
FRAME : Frame reading-out
Reference : When the super EVS (high vertical resolution)
(This position is used to obtain the higher
vertical resolution power.)
mode is set to ON, FIELD is selected forcibly.
4-9. SERVICE Menu
4-67