6-6. Rotary Encoder Replacement
7. Install the new rotary encoder by reversing
the steps of removal.
m
. If the earth plate is found when installing
the ENC-61 board to the inside panel
assembly, assemble the sleeve (ENC1) and
the earth plate as shown in Fig. 1.
. Insert the protruded portion of the rotary
encoder into the square hole of the sleeve
(ENC1) and at the same time, align the
protruded portion of the sleeve (ENC1)
with the groove the of inside panel assem-
bly.
6-12
* :
Depending on the time of production at the factory,
there are sets that do not use the earth plate.
Protruded
*
Earth plate
portion
Protruded
Square hole
portion
Fig.1
Sleeve (ENC1)
Earth plate
Protruded
portion
Groove
Square hole
*
Earth plate
*
Protruded
portion
ENC-61 board
Square
hole
Rotary encoder
Sleeve (ENC1)
HDW-750/750CE V1