Installation
4. Installing the holder assembly sensor
(ID)
Install the new holder assembly sensor (ID) by
inserting the bosses and claws into the five holes
on the MDC-13 board.
5. Operation check
Check that the detection pin moves up and down
smoothly and also returns to the original position.
6. Installing the cassette stopper
(Refer to Section 7-23.)
7. Installing the full top sensor assembly
(Refer to Section 7-16.)
HDW-750/750CE V1
7-27. Holder Assembly Sensor (ID) Replacement
Detection pins
Boss
Holder assembly
sensor (ID)
Claws
Holes
MDC-13 board
Detection pins
Claw
Boss
Hole
Holes
7-91