Sony HDW-750 Maintenance Manual page 359

Installation
3. Installing the reel drive gear assembly
Install the new reel drive gear assembly with
three precision screws.
The standard tightening torque value :
10 x 10 _2
N.m (1 kgf.cm)
m
. Check that the shaft of the one way base
assembly has entered the slot of the link (S)
assembly.
. Check that the shaft of the gear base assembly
has entered the groove of the mechanical deck
assembly. Check also that the pin of the
mechanical deck assembly has entered the hole
of the gear base assembly.
4. Installing the timing belt
(Refer to Section 7-10.)
Adjustments after Replacement
5. Timing belt tension adjustment
(Refer to Section 8-1-5.)
6. Capstan add-on recording adjustment
(Refer to Section 10-5-3.)
HDW-750/750CE V1
Precision screw
P1.4 x 3.5
Precision screw
P1.4 x 3.5
Hole of link (S)
assembly
Groove of mechanical
deck assembly
7-26. Reel Drive Gear Assembly Replacement
One way base
aseembly
Precision screw
P1.4 x 3.5
Hole of gear
base assembly
Reel drive gear
assembly
Shaft of gear
base assembly
Pin of mechanical
deck assembly
7-89