Sony HDW-750 Maintenance Manual page 384

7-33. T Slider Assembly Replacement
8. Installing the T rail
(1) Insert the claw on the rear of the T rail to the
bottom of the T plate assembly and lower the
front of the T rail in the direction of A.
(2) Insert the pin of the T gear assembly into the
hole of the T link assembly and fix it with the
new stop washer.
n
Do not apply excessive force to the T gear
assembly when installing the stop washer.
(3) Install the T rail with six screws.
The standard tightening torque value :
10 x 10 _2
N.m (1 kgf.cm)
(4) Install the spring of the T soft brake.
9. Gear chain phase adjustment
(Refer to Section 8-1-8.)
10. Installing the cassette stopper
Install the cassette stopper with two precision
screws.
(Refer to Section 7-23.)
11. Installing the pinch arm assembly
Install the pinch arm assembly with the new stop
washer.
(Refer to Section 7-29.)
12. Installing the T-tension regulator
assembly
Install the T-tension regulator assembly with the
new stop washer.
(Refer to Section 7-22.)
13. Installing the full top sensor assembly
Install the full top sensor assembly precision
screw.
(Refer to Section 7-16.)
7-114
Precision screws
T slider
P1.4 x 3.5
assembly
Precision screw
P1.4 x 3.5
A
T rail
Precision screw
P1.4 x 3.5
Drum
Brake spring of
T soft brake
Stop washer
Precision screws
P1.4 x 3.5
Hole of T link
assembly
T plate assembly
Pin of T gear assembly
HDW-750/750CE V1