6-12. MS Lid Assembly Replacement
10. Remove the two screws. While removing the
MS lid assembly in the direction of the arrow,
disconnect the flexible card wire from
through the hole.
n
Life of flexible card wire will be significantly
shortened if it is folded. Be very careful not
to fold the flexible card wire.
11. When installing the new MS lid assembly
into the inside panel assembly, insert the
flexible card wire into the hole first. Then,
while pressing the protruded portion of the
MS lid assembly against the sponge on the
back of the MS knob (open), insert it into the
inside panel assembly.
6-24
P1.7 x 2.5
Hole
Flexible card wire
Inside panel assembly
Hole
Flexible card wire
MS lid assembly
Sponge
MS knob
(open)
Protruded portion
MS lid assembly
HDW-750/750CE V1