Sony HDW-750 Maintenance Manual page 399

Installation
10. Installing the MDC-13 board
(1) Align the position-setting hole of the new
MDC-13 board with the position-setting pin
of the mechanical deck assembly and install it
with the 13 precision screws.
The standard tightening torque value :
10 x 10 _2
N.m (1 kgf.cm)
(2) Install the connector gard. (Fig.1)
n
Depending on the time of production at the
factory, there are sets that have no connector
gard.
11. Installing the MDR-14 board
Install the MDR-14 board by reversing the steps
of removal.
12. Installing the timing belt
Install the timing belt.
(Refer to Section 7-10.)
13. Installing the top sensor assembly
Install the top sensor assembly with the precision
screw.
(Refer to Section 7-28.)
14. Installing the gear block assembly
Install the gear block assembly with the three
precision screws.
(Refer to Section 7-24.)
15. Installing the cleaning assembly
Install the cleaning assembly with the precision
screw.
(Refer to Section 7-6.)
16. Installing the end sensor assembly
Install the end sensor with precision screw.
(Refer to Section 7-15.)
17. Installing the full top sensor assembly
Install the full top sensor assembly with precision
screw.
(Refer to Section 7-16.)
18. Installing the mechanical deck
assembly
Install the mechanical deck assembly with five
screws.
(Refer to Section 7-35.)
HDW-750/750CE V1
Precision
Position-setting
screw
hole
P1.4 x 3.5
MDC-13
Position-
board
setting pin
7-36. MDC-13 Board Replacement
Shaft of mechanical
deck assembly
Precision screw
P1.4 x 3.5
Connetor
gard
MDC-13 board
Position-
setting
hole
Shaft of mechanical
deck assembly
View from the side
Shaft of mechanical
deck assembly
Position-setting
pin
Fig1
MDC-13
board
Connetor
gard
7-129