Removing The Media Cutter - Printronix T5000 User Manual

4. Press
5. Press ↑ until "Advanced User" displays.
6. Press + or - until "Enable" displays.
7. Press ↵ to select the "Enable" option. An asterisk (*) appears next to
8. Press
9. Press ↓ until "Media Handling" displays.
10. Press + or - until the "Cut" option displays.
11. Press ↵ to select "Cut." An asterisk (*) displays next to "Cut."
12. Press ↓ until "Cutter Type" displays.
13. Press + or - until "Heavy-Duty" displays.
14. Press ↵ to select "Heavy-Duty." An asterisk (*) displays next to
15. Relock the ↵ key by pressing ↓ and ↵ at the same time, then press
16. If the bar code validator is installed, adjust the validator beam. (Refer to
17. Make sure any media sticking out of the platen goes in the cutter entrance
18. Test the printer cutting operation and print quality by selecting the
19. To save the configuration parameters, refer to "Saving A Configuration"

Removing The Media Cutter

1. Set the printer power to O (OFF).
2. Pull the cutter assembly to the down (open) position.
3. Using the appropriate metric hex key, remove the two screws securing
4. Unplug the RJ-11 connector from the RJ-11 receptacle.
5. Remove the media cutter from the printer.
6. Install the front door assembly on the printer lower support assembly.
. .
until "PRINTER CONTROL" displays.
.
"Enable."
. .
until "MEDIA CONTROL" displays.
.
"Heavy-Duty."
PAUSE to put the printer back online.
"VALIDATOR" on page 84.)
slot.
Diagnostics → Printer Tests menu and printing one of the test patterns.
(Refer to "DIAGNOSTICS" on page 200.)
on page 72.
the cutter bracket to the lower support assembly.
Restore The Printer To Operation
287