Printronix T5000 User Manual page 192

Chapter 3
Emulation Submenus
Slash 0
(From page 140, page 142.) This parameter allows you to print the numeral
"0" with or without the slash. This option applies to all character sets except
OCR A and OCR B.
•
Disable. Zero is printed without a slash.
•
Enable. Zero is printed with a slash.
The factory default is Disable.
Slashed Zero
(From page 145, page 148, page 150, page 152, page 154.)
This parameter allows you to print the numeral "0" with or without the slash.
This option applies to all character sets except OCR-A and OCR-B.
•
Disable. Zero is printed without a slash.
•
Enable. Zero is printed with a slash.
The factory default is Disable.
Slew Relative
(From page 149.) "Slewing" is rapid vertical paper movement. This parameter
determines the number of lines slewed (either 1-15 lines or 1-16 lines) when
an EVFU Slew Relative command is received.
The options are 1-15 lines (the factory default) and 1-16 lines.
SPC Char Set
(From page 135.) Allows you to select the print language character set. See
page 135 for the options.
The factory default is 0500 Internat 5.
SPC Null Supp
(From page 134.) SPC Null Supp stands for SPC Null Suppression.
•
Disable. Ignores nulls. The print position does not move.
•
Enable. Treats nulls as blank spaces.
The factory default is Disable.
SPC Space Supp
(From page 134.) This option is only available in Coax SPC emulation and is
used in LU3/DSC/DSE mode only.
•
Disable. Treats nulls and spaces normally.
•
Enable. If the entire line consists of spaces and nulls, the line will be
discarded.
The factory default is Disable.
192