Power On Igp/Pgl; Primary Subset - Printronix T5000 User Manual

Chapter 3
Emulation Submenus
•
On. Sets the printer to print at print position 1 of the first print line on the
next form.
The factory default is Off.

Power on IGP/PGL

(From page 141.) You can set the IGP/PGL feature so that it is enabled or
disabled when the printer is powered on.
•
Enable. The IGP/PGL is enabled when the printer is powered on. (The
IGP/PGL feature is initialized in the Normal mode.)
•
Disable. The IGP/PGL is disabled when the printer is powered on. (The
IGP/PGL feature is initialized to the Quiet mode.)
The factory default is Enable.
Power-up ^F
(From page 142.)
•
Disable.
•
Enable. Selects free format mode as the power-up default, and selects
the graphics mode ^PY as the power-up default. Free format causes the
VGL to ignore carriage returns, line feeds and all characters below 20 hex
sent from the host.
The factory default is Disable.
Power-up ^PY
(From page 142.)
•
Disable.
•
Enable. Selects the graphics mode ^PY as the power-up default.
The factory default is Disable.
Power-up ^X
(From page 142.)
•
Disable.
•
Enable. Selects the ignore mode as the power-up default, and selects the
graphics mode ^PY as the power-up default. All characters are ignored
until a ^A command is received.
The factory default is Disable.

Primary Subset

(From page 145, page 150.) This menu item allows selection of the desired
primary character subset used by the printer. The factory default is ASCII
(USA).
186